Yaesu DR-1X repeater with SKB 6u wheeled case and D-star controller for raspberryPI

Trending Featured
$650

Includes SKB 6U rolling rack with two shelves. looking for keys but they are TSA keyed so easy to find. I used this for emergency deployments so not used much. Also includes NW digtal radio URDC II raspberry Pi hat. I am looking for the cable, but will send when I can find it ( at my own cost). Local club did not need so must sell. DR-1X features: * Modulation Modes: Conventional FM, 12.5 kHz C4FM Digital (V/D Mode, VFR Mode, DFR Mode) * VHF or UHF operation (cross-band capable) * AMS (Automatic Mode Select) function automatically recognizes the signal as C4FM digital or conventional FM, and then the DR-1X repeater retransmits the signal using the detected communications mode. * 3.5-inch Full Color Touch Panel Operation * Extremely reliable, high RF Output Power: 50W/20W/10W * Emergency Operation: Supports auto-switched backup battery power operation. * Front panel microphone connector is provided for use in repeater transmitter testing, and enables use as a base station. * Built-in large-size monitor speaker with front panel volume control * Full integration with existing repeater controllers using the 15-Pin rear I/O connection. *System Fusion is not compatible with the D-STAR GMSK digital format. The large front panel, color touch-screen permits convenient configuration of the transmitter and receiver frequencies, transmit power output and AMS functions. Simply turn the display switch ON and use the touch panel screen to confirm or change settings. The transmit and receive frequencies, CTCSS tones, squelch, AMS, and other functions are configured by the touch panel screen. Other features: * Internal AC Power Supply * 19 in. Rack Mount Capable * High Stability TCXO included * DSQ (Digital Squelch Code) Signaling Feature * CTCSS and DCS Signaling Feature * ID Announcement Feature * Remote/External Controller Interface * Base Station Operation * Time Out Timer * Firmware Upgradeable DR-1X supplied accessories: * AC Cable * DC Cable for backup battery * PC Connection Cable SCU-20 * Rubber Feet (4) DR-1X specifications: Frequency range 144 to 148 MHz, 430 to 450 MHz Channel steps 5/6.25 kHz Emission type F1D, F2D, F3E, F7W Frequency stability plus/minus 2.5 ppm (-4 degrees F to +140 F) Antenna impedance 50 ohms Supply Voltage AC 100 to 240 V or DC 11.7 to 15.8 V, negative ground Current consumption: 1.5A (Receive) 13A (50 W TX, 144 MHz band) 14A (50 W TX, 430 MHz band) Operating temperature -4 F to 140 degrees F Dimensions: 19 (W) × 3.5 (H) × 15 in. (D) Weight: 22.05 lbs. Transmitter: RF power output 50/20/5 W Modulation type F1D, F2D, F3E Variable Reactance Modulation F7W 4FSK (C4FM) Spurious emission At least 60 dB below Receiver: Circuit type Double conversion super-heterodyne Intermediate frequencies 1st: 47.25 MHz, 2nd: 450 kHz Receiver sensitivity 0.3 uV (Digital 2m/70 cm) BER 1 percent, 0.2 uV (FM 2m/70 cm) 12dB SINAD Adjacent Channel Selectivity Better than 65 dB TYP (20 kHz offset) Selectivity FM 12 kHz/35 kHz (-6 dB/-60 dB) Intermodulation Better than 65 dB TYP (20 /40 kHz offset) Audio output 4 W (4-ohm, THD 10 percent, 13.8 V; internal speaker) DR-1X options that can purchased from a dealer: * DTMF Microphone MH-48A6JA * Hand Microphone MH-42C6J * Voice Guide Unit FVS-2

  • Status : Active
  • Callsign : N1TUX/VE7
  • Phone : 250-689-9128